Flatness of channels can be obtained in the
CH-1 with constant pressure from a spring-loaded pad.
CH-2 Channel Die Set
VIEW DETAILS
The CH-2 is used when the width of the
channel being formed does not permit a spring pad in the die.
CH-3 Channel Die Set
VIEW DETAILS
The CH-3 die set produces an accurate channel
with consistency due to a spring pressure pad. Part removal is made
easier by release wedges on the punch and die.
CH-4 Channel Die Set
VIEW DETAILS
The Ch-4 rocker channel die set is utilized
when a particular stock or excessive radii are required. This die
set produces the given amount of overbend required to make the legs
parallel.
CH-5 Channel Die Set
VIEW DETAILS
The CH-5 die set is designed for radius
channels where overbend is built into the punch and die to
compensate for springback.
CH-6 Channel Die Set
VIEW DETAILS
The CH-6 die set forms a semi-hat channel at
the edge of a sheet. The release wedge in the die and hook stripper
assures positive part removal.
CH-7 Channel Die Set
VIEW DETAILS
The CH-7 die set produces consistently square
corners in one hit due to a spring pressure pad. Part removal is
made easier by release wedges on the punch and die.
CH-8 Channel Die Set
VIEW DETAILS
The CH-8 open hat channel die set forms an
open hat channel in one hit. The pressure pad assures flatness in
the bottom of the channel and easy pat removal.
