|
AMERICAN STYLE HEMMING DIE SETS |
 |
H-1 Hemming Die Set |
VIEW DETAILS |
Is a low cost hemming die set that forms a
teardrop or an open hem in a single handling without die change or
adjustment. The greatest length of fold-over is 2 inches. In the
closing operation, the material must be tilted and held high enough
in the die to enable the punch point to pass the bend edge formed
previously. A slight bow in the length of the sheet can be
anticipated.
- Used for 18-gauge and lighter material.
|
|
|
|
H-2 Hemming Die Set |
VIEW DETAILS |
Is a low cost hemming die set that forms a
teardrop or an open hem in a single handling without die change or
adjustment. In the closing operation, the material must be tilted
and held high enough in the die to enable the punch point to pass
the bend edge formed previously. A slight bow in the length of the
sheet can be anticipated.
- Used for 16-gauge and heavier material.
|
|
|
|
H-4 Hemming Die Set |
VIEW DETAILS |
The H-4 hemming die set to bend the acute
angle in the upper level and to close the hem in the lower level.
- Used for 18-gauge and lighter material.
- Closing operation is adjustable for forming open or closed
hems.
|
|
|
H-5 Hemming Die Set |
VIEW DETAILS |
The H-5 hemming die set to bend the acute
angle in the upper level and to close the hem in the lower level.
- Used for 14-gauge and heavier material.
|
|
|
|
H-6 Hemming Die Set |
VIEW DETAILS |
Is a combination set that eliminates whip-up
of the material. This curbs operator fatigue which is an important
safety factor.
- Used for 18-gauge and lighter material.
|
|
|
|
H-7 Hemming Die Set |
VIEW DETAILS |
The H-7 die set allows for a standard acute
die set to be used as shown for hemming; In addition the middle
section can be locked in the closed position emulating a standard
die holder.
- Closing operation is adjustable for forming open or closed
hems.
- The middle section can be locked in the closed position and
used as a standard die holder.
|
|
|
|
