The W-1 wiping die set produces a flange via
a wiping action.
The sheet is positioned horizontally and eliminates part whip
up.
Shimming an insert at the back of the die will adjust the
small variations in material thickness.
When forming on three or four sides the forming insert can be
sectionalized for varying panel lengths.
W-2 Wiping Die Set
VIEW DETAILS
The W-2 wiping die set produces a flange via
a wiping action.
The sheet is positioned horizontally and eliminates part whip
up.
The spring pressure pad aids in easy part removal.
Shimming an insert at the back of the die will adjust the
small variations material thickness.
When forming on three or four sides the forming insert can be
sectionalized for varying panel lengths.
W-3 Wiping Die Set
VIEW DETAILS
The die set W-3 produces an edge channel in
two strokes. The sheet is positioned horizontally on the die and
located against the back gauge for producing the second bend on the
following stroke.
The bends are formed down and eliminating whip up.
Shimming an insert at the back of the die will adjust the
small variations in material thickness.
When forming on three or four sides the forming insert can be
sectionalized for varying panel lengths.
Over bend can be built into the die set to compensate for
spring back in heavier material
W-4 Wiping Die Set
VIEW DETAILS
The W-4 wiping die set produces a flange via
a rotary wiping action.
The sheet is positioned horizontally and eliminates part whip
up.
Shimming the leader on the backside of the die will adjust the
small variations in material thickness.
When forming on three or four sides the W-4 can be designed
with a sectionalized forming insert for varying panel lengths.
Requires 30% less tonnage then other wiping dies.
Over bend can be built into the die set to compensate for
spring back
